390_22002_2
Topthema: Sound im Audi
Audio System RFIT Audi A6 C8 Evo2 – 20er System für Audi A6
Von Audio System gibt es eine Vielzahl an Nachrüstlautsprechern für Audi. Wir schaffen den Überblick und testen das RFIT Set für den A6 C8.
>> Mehr erfahren>> Alle anzeigen
487_23559_2
Topthema: Totale Eleganz
Arendal 1528 Monitor 8
Form follows function ist ja ein geflügeltes Wort für Design um die technischen Notwendigkeiten herum. Dass man aber auch beide Aspekte gleichwertig behandeln und auf die Spitze treiben kann, zeigt uns die neue Serie 1528 von Arendal.
>> Mehr erfahren>> Alle anzeigenKategorie: Verstärker Endstufen
Ausstattungsliste: Crestron AMP-2210T
Ausstattung & technische Daten
| Technische Daten | |
| Audio | |
| Typical of 2 mono amplifier channels: | |
| Input Signal Type | Balanced or unbalanced analog line-level |
| Output Signal Types | 4/8 Ohm, 70 Volt, or 100 Volt |
| Output Power | 120 Watts at 8 Ohms; |
| 210 Watts at 4 Ohms; | |
| 420 Watts at 8 Ohms bridged; | |
| 120 Watts at 70 or 100 Volts (Transformer isolated) | |
| Damping Factor | >100 |
| Protection | Over Current, Over/Under Voltage, Over Temperature, DC Offset |
| Frequency Response | 20Hz to 20kHz ±0.5 dB at 4/8 Ohms; |
| 80Hz to 20kHz +0/-3 dB at 70/100 Volts | |
| THD | 0.05% @ 1kHz, full rated power at 4/8 Ohms, 8 Ohms Bridged, or 70/100 Volts |
| 0.1% @ 20Hz to 20kHz, 120W at 8 Ohms; | |
| 0.2% @ 20Hz to 20kHz, 210W at 4 Ohms; | |
| 0.1% @ 20Hz to 20kHz, 420W at 8 Ohms Bridged; | |
| 0.1% @ 80Hz to 20kHz, 120W at 70/100 Volts | |
| S/N Ratio | >103 dB, A-weighted |
| Crosstalk | >70 dB @ 1kHz |
| Gain | 23 dB with INPUT LEVEL control set at 12 o |
| Input Sensitivity | 2.22 Vrms for rated output power with INPUT LEVEL control set at 12 o |
| Input Detection Threshold | 40 mV RMS @ 1 kHz |
| Input Level Adjustment | ±10 dB from nominal |
| Connectors | |
| G | 6-32 screw, chassis ground lug |
| INPUT CH 1 – 2 | (2) 3-pin 3.5mm detachable terminal blocks; Balanced/unbalanced line-level audio inputs; Input Level: 5.3 Vrms maximum with INPUT LEVEL control set at minimum position; Input Impedance: 24k Ohms balanced, 12k Ohms unbalanced |
| SPEAKER OUTPUT CH 1 – 2 | (2) 4-pin 7.62mm 15A detachable terminal blocks; 4Ω/8Ω and 70/100V power amplifier outputs; Wire Size: Terminals accept up to 14 AWG |
| REMOTE | (1) 6-pin 3.5mm detachable terminal block; Provides (2) remote control inputs; enables independent power control of each channel via local jumpers or remote contact closures; inputs may be safely paralleled for global control |
| FUSE T6.3AH 250V | Main fuse holder; 5x20 mm, 250V, 6.3AH, time-lag, high-rupture rated |
| 100-240V~50/60Hz | (1) IEC C14 male chassis plugs, main power input; Mates with removable power cord (included) |
| Controls & Indicators | |
| PWR | (1) dual-color LED, green indicates ACTIVE state, yellow indicates STANDBY state |
| INPUT 1 – 2, SIGNAL | (2) green LEDs, indicate signal presence on each corresponding channel |
| OUTPUT 1 – 2, CLIP | (2) amber LEDs, indicate a clipping condition on each corresponding channel |
| OUTPUT 1 – 2, FAULT | (2) red LEDs; indicate over-temperature, over-current, over or under power supply voltage, or DC offset condition on each corresponding channel |
| INPUT CH 1 – 2 LEVEL (rear) | (2) Rotary input boost/attenuate adjustments w/center detent at nominal |
| SPEAKER OUTPUT CH 1 – 2, 100V / 70V / 4/8Ω (rear) | (2) 3-position slide switches, select the output configuration for each corresponding channel |
| ON/REMOTE/OFF (rear) | (1) 3-position slide switch; selects between all channels powered on, all channels powered off, or remote control of each individual channel |
| Power Requirements | |
| Main Power | 100-240 Volts AC, 50/60 Hz |
| Power Consumption | 62 Watts @ 8 Ohms, all channels driven at 1/8th output power; |
| 88 Watts @ 4 Ohms, all channels driven at 1/8th output power; | |
| 63 Watts @ 70/100V, all channels driven at 1/8th output power; | |
| 26 Watts, all channels idle; | |
| <1 Watt in standby | |
| Environmental | |
| Temperature | 41° to 104°F (5° to 40°C) |
| Humidity | 10% to 90% RH (non-condensing) |
| Heat Dissipation | 110 BTU/Hr @ 8 Ohms, all channels driven at 1/8th output power; |
| 121 BTU/Hr @ 4 Ohms, all channels driven at 1/8th output power; | |
| 113 BTU/Hr @ 70/100V, all channels driven at 1/8th output power; | |
| 89 BTU/Hr, all channels idle; | |
| <3.4 BTU/Hr in standby | |
| Enclosure | |
| Chassis | Metal with black finish, vented top and sides, convection cooled |
| Front Panel | Metal, black finish with polycarbonate label overlay |
| Mounting | Freestanding or 1U 19-inch rack-mountable (adhesive feet and rack ears included) |
| Dimensions | |
| Height | 1.70 in (44 mm) |
| Width | 17.28 in (439 mm); |
| 19.0 in (483 mm) with rack ears | |
| Depth | 14.59 in (371 mm) |
| Weight | 15.1 lb (6.9 kg) |
